GOINGMAKE Thin Rip Jig
Repeats one strip width without measuring.
- Reach
- 2-5/8 to 8 in from the slot center to the blade
- Thinnest strip
- 1/32 in
- Bearing
- One-way roller: the board moves forward, not back
- Scales
- Inch and mm, laser engraved
Description
Description
Ripping a stack of edge banding or inlay strips goes wrong when you measure between the fence and the blade for every pass. The Thin Rip Jig locks in your miter slot in front of the blade and gives the board one fixed point to touch. After each cut, slide the fence over until the board meets the bearing again, and the next strip matches the first.
Setup follows the scale. Bring the bearing close to the blade, move the indicator to the nearest mark, then set the strip width. Strips can be as thin as 1/32 in, and the jig reaches 2-5/8 to 8 in from the slot center to the blade. Its one-way roller bearing lets the board move forward and not back.
It fits 3/8 x 3/4 in T-slots and U-slots plus 1/4 x 3/8 in T-slots, so it works on a table saw, a band saw or a router table. Black and Red are the same jig with the same inch and mm scales. Pick the color you will spot first on a crowded bench.
Specifications
The GOINGMAKE Thin Rip Jig, by the numbers
| Reach | 2-5/8 to 8 in from the slot center to the blade |
|---|---|
| Thinnest strip | 1/32 in |
| Bearing | One-way roller: the board moves forward, not back |
| Scales | Inch and mm, laser engraved |
| Fits | 3/8 x 3/4 in T or U slot, 1/4 x 3/8 in T-slot |
| Works on | Table saw, band saw, router table |
| Material | Aluminum alloy |
| Model number | GM8 |
| Your pick | Black |
The Thin Rip Jig sits with 3 other jigs on the saw jigs and guides shelf of the GOINGMAKE collection.
Questions
Questions about the GOINGMAKE Thin Rip Jig
Will the GOINGMAKE thin rip jig fit your band saw?
If the band saw table has a 3/8 x 3/4 in T-slot or U-slot, or a 1/4 x 3/8 in T-slot, yes. The jig reaches 2-5/8 to 8 in from the slot center. Read thin strips and repeat rips for the method.
Is the red GOINGMAKE thin rip jig different from the black one?
Only in color. Both reach 2-5/8 to 8 in from the slot center, cut strips down to 1/32 in, carry inch and mm scales and fit the same three slot sizes.
A table saw cuts fingers as easily as wood. The agencies below put the numbers on it and say what keeps hands out of the line of the cut.
More from the shop
You may also need
TSPG58
GOINGMAKE Track Saw Parallel Guide System
Turns your track saw rail into a rip fence
GOINGMAKE Table Saw Dial Indicator Gauge
Measures blade and fence against the miter slot
0514
GOINGMAKE Track Saw Parallel Guide with Magnifier
Parallel guide that reads its scale at a glance
