Filter
GM-G140
GOINGMAKE Corner Clamps, 45 and 90°
Holds two boards at 90 or 45° for glue-up
G19
GOINGMAKE Bench Dog Clamp, 3/4 in
Holds work flat on a 3/4 in dog-hole bench
Compare
GOINGMAKE clamps and sharpening side by side
| Model | Angles | Rod | Blades | Rating | From |
|---|---|---|---|---|---|
| Honing Guide System | 15 to 45° in 5° steps, and 17 to 42° in 5° steps | - | Chisels and plane irons 5/32 to 3 in | 4.4 (379) | $44.99 |
| Corner Clamps, 45 and 90° | 90 and 45° | - | - | 4.4 (138) | $35.99 |
| Bench Dog Clamp, 3/4 in | - | 3/4 in, CNC-machined | - | 3.9 (90) | $29.99 |
Hold it square, keep it sharp
Glue-ups go wrong at the corners. The corner clamps come as a pair and hold two boards at 90 or 45 degrees for boxes, drawers and frames. On a dog-hole bench, the bench dog clamp drops into a 3/4 in hole and holds stock up to 1-3/4 in thick under soft pads.
A sharp chisel cuts cleaner than a new jig. The honing guide clamps blades from 5/32 to 3 in and sets angles from 15 to 45 degrees, so each pass on the stone holds the same bevel.
Every bench tool on this shelf belongs to the GOINGMAKE range. Before you set up a bench tool, read Pocket holes, dowels and dog holes: drilling with a jig instead of by eye.
Questions
Questions about GOINGMAKE clamps and sharpening
Will your chisels fit the GOINGMAKE honing guide?
Chisels and plane irons from 5/32 to 3 in wide. Its fixture sets bevels from 15 to 45 degrees in 5 degree steps, plus 17 to 42.
How many corner clamps do you get in the GOINGMAKE set?
Two. Each holds a corner at 90 or 45 degrees, with a shoulder that lines up the edges of both boards.
How thick a board can you hold with the GOINGMAKE bench dog clamp?
Stock up to 1-3/4 in, through a 3/4 in dog hole, with soft pads against the face of the board.